padsbank0.h

// THIS HEADER FILE IS AUTOMATICALLY GENERATED -- DO NOT EDIT

/*
 * Copyright (c) 2021 Raspberry Pi (Trading) Ltd.
 *
 * SPDX-License-Identifier: BSD-3-Clause
 */

#ifndef _HARDWARE_STRUCTS_PADSBANK0_H
#define _HARDWARE_STRUCTS_PADSBANK0_H

#include "hardware/address_mapped.h"
#include "hardware/regs/pads_bank0.h"

// Reference to datasheet: https://datasheets.raspberrypi.com/rp2040/rp2040-datasheet.pdf#tab-registerlist_pads_bank0
//
// The _REG_ macro is intended to help make the register navigable in your IDE (for example, using the "Go to Definition" feature)
// _REG_(x) will link to the corresponding register in hardware/regs/pads_bank0.h.
//
// Bit-field descriptions are of the form:
// BITMASK [BITRANGE]: FIELDNAME (RESETVALUE): DESCRIPTION

typedef struct {
    _REG_(PADS_BANK0_VOLTAGE_SELECT_OFFSET) // PADS_BANK0_VOLTAGE_SELECT
    // Voltage select
    // 0x00000001 [0]     : VOLTAGE_SELECT (0)
    io_rw_32 voltage_select;

    _REG_(PADS_BANK0_GPIO0_OFFSET) // PADS_BANK0_GPIO0
    // (Description copied from array index 0 register PADS_BANK0_GPIO0 applies similarly to other array indexes)
    //
    // Pad control register
    // 0x00000080 [7]     : OD (0): Output disable
    // 0x00000040 [6]     : IE (1): Input enable
    // 0x00000030 [5:4]   : DRIVE (1): Drive strength
    // 0x00000008 [3]     : PUE (0): Pull up enable
    // 0x00000004 [2]     : PDE (1): Pull down enable
    // 0x00000002 [1]     : SCHMITT (1): Enable schmitt trigger
    // 0x00000001 [0]     : SLEWFAST (0): Slew rate control
    io_rw_32 io[NUM_BANK0_GPIOS]; // 30
} padsbank0_hw_t;

#define padsbank0_hw ((padsbank0_hw_t *)PADS_BANK0_BASE)

static_assert( NUM_BANK0_GPIOS == 30, "");

#endif